Subject | Text |
Akai AP-A200 turntable speed problem | Hi,
I have an Akai AP-A200 turntable with a speed problem.
When is working the speed is uncont |
TDA 1085C Microcontroller for speed of asink. motor | Hi,
My name is Nedjeljko; I have one problem with this regulator of speed for asynchrony motor: : |
|
change speed on vcr | Hi,
I'm not sure this is the right place to leave this message, but here goes.
I have a |
Please code Radio BECKER Traffic Pro High SpEED | Hallo !
Please code radio BECKER Traffic Pro High Speed
Model No. : BE7825
Serial No. : 450 |
becker traffic pro high speed code | hallo
kann mir bitte jemand weiterhelfen?
habe in meinem lkw das traffic pro high speed 7821.
|
turntable speed problem | My Technics SL 1900, Direct drive, Turntable turns too fast. There is no service in the area. Is it |
Re: Please code Radio BECKER Traffic Pro High SpEED | [quote:2fc599fc6d="bochyn"]Hallo !
Please code radio BECKER Traffic Pro High Speed
Model No. : |
| This is turning more into a blog :-) Anwyay, I'm thinking of replacing the diode with a generic UF40 |
| Hi you can download it from that link , but unfortunatelly the speed is very poor !! :(
http://yasi |
| You can try to put a 400 Volts rated capacitor across the 230 Volts motor terminals. (50 to 80 µF.) |
Re: Studioworks 775n (CB775BN) brightness adjustment??? | [quote:d427f3d2dc="Benjovy"]Hi all,
My monitor brightness controll is 100% on the OSD & my moni |
| Windscreen wiper motors are usually 2 speed anyway, can you switch it to a lower speed? What do you |
the encoder | I don't understand. The out signal is linar with the speed of the motor means that the higher the r |
| [quote:d75d14f61d="gary"]ring bose customer services and they will send you an update disc, if that |
Error code | C 0910 =2nd Drawer Paper Lift-up Failure
C 0d50=Duplex Unit Drive motor M31`s Fail to Turn
C 0F20= |
Wireless Mic | I have a Light speed 2000DX wireless mic system. I purchased it from a individual. He said it worked |
How to protect and safeguard the audio-visual data carrier? | 1. The audio frequency disc
Now the audio carrier most possibly found in the library is the dis |
|
pls help in monitor troubleshootin | hi, need help in troubleshooting a proview 17 inch monitor, it was a dead set then i replaced a defe |
Can someone help me with my Faulty LCD TV PLEASE | iv uploaded some photos to try show what im talking about its a Beko and been fine up untill the oth |
Sony Handycam model CCD-TR416 | Hi,
I was wondering if anyone knwe if how serious a problem I have with a Sony Handycam CCD-TR416. |
building a generator | how do I use a standard 240v single phase ac motor driven by a petrol engine to create 240vac betwee |
RAM AND HDD UPGRADE | Main Chipset Intel 830MG
System Bus/FSB 133 MHz
BIOS Size/Name Inside Plug and Play (1.0a) 1x 256K |
| Well, yeah, you are messing with relatively high power equipment and can get into embarrassing situa |
I need service manual for Curtis 1225-2401 controller | Hi, guys,
I have some faulty of this type controllers and try to repair them. These controllers are |
| Also, a little more information.
Just wouldn't power up one day?
Was running fine, then suddenly |
| Does the CD ROM slide out of the front (side) when a latch is undone?
Does your computer reconize |
| Problem is... how to control the output voltage under varied load conditions.. you may well end up w |
TV SABBA PH02A SERVICE MENU | Please someone,
I need entering procedure in service menu for TV SABBA P001 Chassis PH02A .Process |
| Yes I did They voltage was @9.2V. I mess up on amp. Will have to redo that part...
Does any body k |
ivtec | My friends i went shopping for a printer and got one very cheap at Walmart, i got a Lexmark Z2300 a |